Du är här: Startsidan - Verktygsmaskinprober och programvara - Produktlista - NC3

NC3

Denna sida finns för närvarande inte på ditt språk. Du kan översätta den automatiskt med Google Translate. Vi ansvarar inte för att tillhandahålla denna tjänst och vi har inte kontrollerat översättningsresultaten.
Kontakta oss om du behöver ytterligare hjälp.

Sidans innehåll Nedladdningsbara filer Ring närmaste kontor Kontakta oss online

NC3 cut-out Compact non-contact laser tool setting and tool breakage detection system for machining centres.

About NC3

NC3 cut-out The NC3 is a compact 2 axis non-contact tool setting probe, with broken tool detection capability.

Tools as small as Ø0.2 mm can be measured anywhere along the laser beam and set-up is more simple than focused laser systems as there is no focal point to identify.

The NC3 offers high repeatability, low air consumption and a rapid tool-breakage detection cycle.

The NCi-5 interface is required for use with NC3 and other non-contact tool setting systems. The NC3 is operated using Renishaw's macro-based non-contact tool setting software.

NC3 specification

Specification
Laser type	Class 2, Visible red light < 1 mW 670 nm
Electrical connection	Hard-wired
Repeatability of trigger points (2 sigma)	±0.15 µm (0.000006 in)
Minimum tool diameter for measurement	Ø0.2 mm (0.008 in)
Minimum tool diameter for breakage detection	Ø0.1 mm (0.004 in)
Air protection system	Supply pressure greater than 3 bar. Air usage 6 litres / min.
Power supply	12 V to 30 V, 120 mA
Power-up time	< 0.5 seconds
Temperature limit	Operating: +5 °C to + 50 °C Storage: -10 °C to + 70 °C
Outside length	135 mm (5.31 in)
Internal transmitter and receiver separation	80 mm (3.15 in)
Sealing	IP X8
Mounting	Single M10 / M12 fixing. M4 mounting holes also provided.
Compatible interface	NCi-5